Making the wind settings easier to adjust. Top and bottom sprockets new couplers and bolts. They are one more tool in the box. Easiest way to check is to cut a couple of your larger stalks and see if they will go between the plates or not machine shutoff of course. Even though Neufeld harvests thousands of acres a year, he doesn't buy the largest combine available. CIH head shelling Help!
Metal Fabricating Glossary
I always carry a coupling for that shaft in the combine. Even so, if corn is really dry you're going to see an increase in header shellage. It is just a short telescoping shaft with a U joint at each end with a spring loaded pin to lock it onto the hex shaft at each end. Definitely run your head as slow as possible at 3 to 4 mph and keep your header height as high as possible to just stay under the ear height. Note my book is for series combines with rpm shaft speed.
IRON Search - Hundreds of Used Case IH Header Combines For Sale By Dealers and Owners
That way you didn't have to hunt for the right dia socket. With good knives, if the deck plates are a little too tight won't hurt much - obviously the stalks have to be able to fit in far enough for the knives to grab them, but good knives adjusted properly, with the gathering chains pulling everything in, will take care of the rest. Combine Rotor Speed rpm. Heavy duty round rod construction for extended life. You can watch behind the head out the side of the cab and see the difference it makes. For example, finding two kernels per square foot or a single ear in a row behind a combine represents a 1-bushel-per-acre loss.
Especially in variable corn, you can adjust them going across the field so you aren't butt shelling in the lower yielding areas, and open them up for more capacity in the higher, larger stalk areas. Set trash knives on corn heads close to the snapping rolls to prevent weeds and stalk material from wrapping on the rolls. My head is red, but the hydraulic deck plate concept is the same. I took it off and made one up for my r5. Just open enough where the stalks are going through good? Feeder House Face Plate.